![]() ![]() ![]() I have checked the trainer menus on the TX and both Wired and Wireless trainer modes are set to "inhibit", I have tried setting the TX to the other trainer modes to see if they would work but they dont (other modes were: Programmable Master, Pilot Link Master and Slave) I am new to the hobby so my understanding of the Transmitter is limited. I have tried uninstalling the driver and plugging the dongle in again but this has not resolved the issue. Unfortunately this is where things stop working, the configuration wizzard does not recognize any inputs from my controller. I plug in the DX6 using the trainer port and it turns on (without moving the power switch on the TX), I then go into the "Properties" tab and select configure as per the instructions on your site. ![]() at this point windows recognizes the Ikarus dongle is plugged in and shows the game controller in the "setup game controller" menu. I have connected the Y-Adapter to the USB interface and plugged that into my USB port (as per instructions). USB Interface Connector ( …rface-for-aeroflyrc7.html) I bought the following hardware from your online store: I have a Spektrum DX6 Transmitter (the newly released edition ( …fault.aspx?ProdId=SPM6700) ) that I am wanting to use in AeroflyRC7. I need help with getting my PC to recognize inputs from my transmitter that is plugged into a USB port using your hardware. Firstly thank you Dev's for the excellent Simulator, I have had a great time learning and improving my flying skills. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |